Altmil table design allow for mounting board for through dove tails

Will the new Altmill with table have the ability to mount a board on end for cutting through dove tails?

Hi Lyle,

Somewhere in the last few months after I heard about the Altmill, I either read in a post, or saw in a YouTube video that the Altmill would have that capability - by using the back of the table surface. I’ve been looking for that info again, to verify what (if any) type of mods would have to be made when setting it up.

I’ll keep looking - but if you do find the answer please post it - Don

Don, I appreciate the help. I’ll keep looking as well.
Thanks,