# Are there some fonts that just dont work? **URL:** \ **Category:** Carbide Create\ **Created:** [March 9, 2023, 4:50pm UTC](https://forum.sienci.com/t/are-there-some-fonts-that-just-dont-work/8274 "2023-03-09T16:50:21Z")\ **Posts on this page:** 1\ **Showing post:** 10
**Author:** ![\_Michael](https://forum.sienci.com/user_avatar/forum.sienci.com/_michael/32/2962_2.png) [@\_Michael](https://forum.sienci.com/u/_Michael)\ **Post date:** [March 10, 2023, 1:11am UTC](https://forum.sienci.com/t/are-there-some-fonts-that-just-dont-work/8274/10 "2023-03-10T01:11:19Z")
> [@Minidb](#): > > using a 90deg bit as an example, is it the depth set to .125 then the width will be .0625 or .25 @Minidb I think that maybe you have it backwards, the depth doesn’t set the width of a v carve, it’s the width that sets the depth. The bit will only go as deep as it needs to to fit between the lines. There is a flat depth with a v carve in Vectric software but that does not make the bit go that deep, what it does is stop the bit from going any deeper than the flat depth. [Here is a link](https://forum.sienci.com/t/re-center-of-letters-carving-out/7203/25) to a post I made with a drawing of how v carve depth works. --- _[View the full topic](https://forum.sienci.com/t/are-there-some-fonts-that-just-dont-work/8274)._