# Autospin Drama & Fix - In case someone has the same issue

**URL:** <https://forum.sienci.com/t/autospin-drama-fix-in-case-someone-has-the-same-issue/27156>\
**Category:** ❓ Something's Up\
**Created:** [September 24, 2026, 7:31pm UTC](https://forum.sienci.com/t/autospin-drama-fix-in-case-someone-has-the-same-issue/27156 "2026-09-24T19:31:29Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Windlasher](https://forum.sienci.com/letter_avatar_proxy/v4/letter/w/e9c0ed/32.png) [@Windlasher](https://forum.sienci.com/u/Windlasher)\
**Post date:** [September 24, 2026, 7:31pm UTC](https://forum.sienci.com/t/autospin-drama-fix-in-case-someone-has-the-same-issue/27156/1 "2026-09-24T19:31:29Z")

</div>

So My Autospin Stopped in the middle of a job. Im glad that it was a test piece so I didnt have to eat an expensive chunk of wood. I emailed support and posted on Facebook because it was the middle of the night to see any suggestions. Brushes were suggested. Well, I spent the entire morning tracking down CB408 brushes, even though I didn’t think that was the problem because I don’t actually use my longmill enough to have worn them down. The last time I had something where the brushes needed to be replaced, it acted kind of wonky for a bit and then died. This just stopped. I finally managed to get my hands on some, and when I went to replace them, I pulled one out, and it looked great. What I did notice was that the covers were loose. They didn’t crank them down at all at the factory, and hey both had vibrated out. A little QC issue there, Sienci, but I am glad that it was something simple.