Hi.
I setup a new bit in carveco but when i go to use it with gsender I keep getting error 22 undefined feed rate. I have triple check the bit setup settings and all seams to be good. I have setup other bits with no issues.
Just stumped
Hi.
I setup a new bit in carveco but when i go to use it with gsender I keep getting error 22 undefined feed rate. I have triple check the bit setup settings and all seams to be good. I have setup other bits with no issues.
Just stumped
Wouldn’t the feed rate be found in the project code ?
@Aerohawk @Truthfire Welcome to the group, guys. I’m sure that you will find it a friendly, helpful place.
@Aerohawk Can you post your gcode file? It may let us see what your issues is all about.