# gSender - Hal + Rotary support Early Alpha

**URL:** <https://forum.sienci.com/t/gsender-hal-rotary-support-early-alpha/8462>\
**Category:** 📌 Release Thread\
**Created:** [March 31, 2023, 7:41pm UTC](https://forum.sienci.com/t/gsender-hal-rotary-support-early-alpha/8462 "2023-03-31T19:41:50Z")\
**Posts on this page:** 1\
**Showing post:** 28

<div class="post-metadata">

**Author:** ![AndyCXL](https://forum.sienci.com/letter_avatar_proxy/v4/letter/a/6a8cbe/32.png) [@AndyCXL](https://forum.sienci.com/u/AndyCXL)\
**Post date:** [April 26, 2023, 3:54pm UTC](https://forum.sienci.com/t/gsender-hal-rotary-support-early-alpha/8462/28 "2023-04-26T15:54:44Z")

</div>

I have spotted one more oddity with this Alpha release. I was cutting a reasonably large .nc file (3.4MB), rotary, origin = Fusion 360, and clicked the visualiser ‘lightweight mode’ slider - the visualiser view reset, and the job halted and needed to be re-started. I had run the same job this week and no stop/reset had happened - it seems only the action of clicking the slider triggered it.  
I don’t believe I have noticed this behaviour before in use of Released or Edge builds. I can post the .nc file if it will help understand the issue.

---

_[View the full topic](https://forum.sienci.com/t/gsender-hal-rotary-support-early-alpha/8462)._