# Inlay using carbide create **URL:** \ **Category:** Carbide Create\ **Created:** [April 6, 2022, 1:13am UTC](https://forum.sienci.com/t/inlay-using-carbide-create/5547 "2022-04-06T01:13:13Z")\ **Posts on this page:** 4\ **Page:** 1
**Author:** ![abes39](https://forum.sienci.com/letter_avatar_proxy/v4/letter/a/ed655f/32.png) [@abes39](https://forum.sienci.com/u/abes39)\ **Post date:** [April 6, 2022, 1:13am UTC](https://forum.sienci.com/t/inlay-using-carbide-create/5547/1 "2022-04-06T01:13:13Z")
I created a small inlay project using Carbide Create Pro. However, G-Code does not insert a Pause to allow for tool changes. What is the best solution to this? ---
**Author:** ![ozguzzi](https://forum.sienci.com/letter_avatar_proxy/v4/letter/o/958977/32.png) [@ozguzzi](https://forum.sienci.com/u/ozguzzi)\ **Post date:** [April 6, 2022, 3:32am UTC](https://forum.sienci.com/t/inlay-using-carbide-create/5547/2 "2022-04-06T03:32:54Z")
I don’t know CC, but you more than likely need separate G code files for each tool. ---
**Author:** ![Jammer](https://forum.sienci.com/letter_avatar_proxy/v4/letter/j/df705f/32.png) [@Jammer](https://forum.sienci.com/u/Jammer)\ **Post date:** [April 6, 2022, 11:37am UTC](https://forum.sienci.com/t/inlay-using-carbide-create/5547/3 "2022-04-06T11:37:23Z")
I use [ncviewer.com](http://ncviewer.com) and separate the two tools into individual files. Let me know if you need more detail. ---
**Author:** ![SRuisi](https://forum.sienci.com/letter_avatar_proxy/v4/letter/s/ea666f/32.png) [@SRuisi](https://forum.sienci.com/u/SRuisi)\ **Post date:** [April 11, 2022, 7:42pm UTC](https://forum.sienci.com/t/inlay-using-carbide-create/5547/4 "2022-04-11T19:42:01Z")
In CC, I believe you can edit each individual Tool/toolpath portion. As an example: disable the second, third etc and when 1st is finished change tools and then disable first and re-enable second and so on.