Issue with ramping operation?

This is my first time using ramping, so maybe it’s me… But at the beginning of my surfacing run, I have a ramping operation (surfacing my spoilboard). As seen in the picture, gSender thinks I have completed about 7 lines or so just from the initial ramping, resulting in my job being 20ish% “done”. This becomes a problem further up when the last line is “complete”, I got an error message saying invalid command. I stopped it before it was actually complete, as I wasn’t sure what would happen.

Important things:
gSender 1.1.4
Carveco Maker

More important things - first bit of gcode during ramping:
T1
G17
G20
G90
G0Z0.2000
G0X0.0000Y0.0000
S17000M3
G0X0.5000Y0.5000Z0.2000
G1Z0.0400F7.0
ok
ok
ok
ok
G1X2.5000Y0.5000Z0.0050
ok
ok
G1X0.5000Y0.5000Z-0.0300
ok
ok
G1X49.2952Y0.5000F80.0
Y1.1897
ok
X0.5000Y1.1897
ok
X0.5000Y1.8794
ok
X49.2952Y1.8794
Y2.5692
ok
X0.5000Y2.5692
X0.5000Y3.2589
ok
ok
X49.2952Y3.2589
Y3.9486
ok
X0.5000Y3.9486
ok
X0.5000Y4.6383
ok
ok
X49.2952Y4.6383
Y5.3281
ok
X0.5000
ok
X0.5000Y6.0178
ok
X49.2952Y6.0178
ok
Y6.7075
X0.5000
ok
X0.5000Y7.3972
ok
X49.2952Y7.3972
ok
Y8.0870

Hi Jason, just for clarification is this surfacing code you’ve made in carveco or is this using the surfacing tool in gSender?

Surfacing code from Carveco