# Machine won’t move

**URL:** <https://forum.sienci.com/t/machine-won-t-move/2182>\
**Category:** ❓ Something's Up\
**Created:** [January 1, 2021, 9:28pm UTC](https://forum.sienci.com/t/machine-won-t-move/2182 "2021-01-01T21:28:13Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![gwilki](https://forum.sienci.com/user_avatar/forum.sienci.com/gwilki/32/366_2.png) [@gwilki](https://forum.sienci.com/u/gwilki)\
**Post date:** [January 1, 2021, 10:40pm UTC](https://forum.sienci.com/t/machine-won-t-move/2182/2 "2021-01-01T22:40:13Z")

</div>

@Cjohn31875 Craig: There are several threads here talking about this issue and setting out lots of possible solutions. The most recent is this one

> [@Continued issues](https://forum.sienci.com/t/continued-issues/2162):
>
> Ok, status is installed new controller. All seemed fine, cut new waste board holes and t nut recess ([Spoilboard project](https://forum.sienci.com/t/spoilboard-project/236)) yesterday, the machine drilled mounting holes, all seemed perfect. Did the surfacing and it started ok but stopped after a few minutes, maybe cut a 6X6" area. Restarted after putting it back to zero and it started cutting in a different area. BTW I have disabled all power settings to either disabled or Never. Now won’t do anything. Replaced usb cable, re installed ugs platf…

With any kind of luck, the advice in that thread and in the others in the Machine Support category will get you moving again.

If not, let us know what steps you have taken and maybe we can help.

---

_[View the full topic](https://forum.sienci.com/t/machine-won-t-move/2182)._