# Makita Trim Router ~ Speed Settings

**URL:** <https://forum.sienci.com/t/makita-trim-router-speed-settings/6041>\
**Category:** 🧠 New Wisdom\
**Created:** [June 5, 2022, 8:45pm UTC](https://forum.sienci.com/t/makita-trim-router-speed-settings/6041 "2022-06-05T20:45:25Z")\
**Posts on this page:** 1\
**Showing post:** 15

<div class="post-metadata">

**Author:** ![RickW](https://forum.sienci.com/letter_avatar_proxy/v4/letter/r/aca169/32.png) [@RickW](https://forum.sienci.com/u/RickW)\
**Post date:** [June 20, 2022, 5:18pm UTC](https://forum.sienci.com/t/makita-trim-router-speed-settings/6041/15 "2022-06-20T17:18:45Z")

</div>

@Fredymac, did you get fire or just smoke? Not stupid, that’s how we learn new stuff. I usually run 1/4" bits at #4 on the Makita router and 100"-120" / min. depending on wood density. The chips come out warm and the bit stays cool. The Vectric software has a built in chip load calculator to use as a starting point so if you get close with the speed and a conservative feed rate, you can increase or decrease the feed rate in gsender to get warm chips and a cool bit and take a note of the feed rate you are using FOR EACH TYPE OF WOOD. I have not run the router above #4 yet…  
@jepho yep, MDF is bad for lungs! I use hot glue for hold down so never surfaced the spoil board, only the board that is glued to it. I do have a lot of oops depth settings that went into the spoil board though doing cutouts. When I can’t glue around the oopsies, I’ll just flip the board over and carry on. I will plug your speed settings into Vectric so it will recalculate the chip loads and thanks again for your testing!

---

_[View the full topic](https://forum.sienci.com/t/makita-trim-router-speed-settings/6041)._
