# Vertical storing options **URL:** https://forum.sienci.com/t/vertical-storing-options/12052 **Category:** 📄 General **Created:** [April 24, 2024, 12:40am UTC](https://forum.sienci.com/t/vertical-storing-options/12052 "2024-04-24T00:40:16Z") **Posts on this page:** 1 **Showing post:** 7
### Author: ![Brayvin](https://forum.sienci.com/user_avatar/forum.sienci.com/brayvin/32/6957_2.png) [@Brayvin](https://forum.sienci.com/u/Brayvin) #### Post date: [May 6, 2024, 5:16pm UTC](https://forum.sienci.com/t/vertical-storing-options/12052/7 "2024-05-06T17:16:58Z")
> [@What are your plans for a table?](https://forum.sienci.com/t/what-are-your-plans-for-a-table/95/49): > > Getting there > [@What are your plans for a table?](https://forum.sienci.com/t/what-are-your-plans-for-a-table/95/60): > > Space limitations have prevented me from acquiring a CNC in the past. My shop is in one half of a two car garage because my boss insists on parking her car on her half. I managed to claim the ‘air rights’ and decided to mount my longmill on a platform that I could hoist out of the way when not in use. I bought a Racor 4’x4’ ceiling lift with a 250 lb capacity on Amazon for around $250 US. It works great. When lowered, I clamp it to the MFT top on my workbench to keep it from swinging around. … > [@What are your plans for a table?](https://forum.sienci.com/t/what-are-your-plans-for-a-table/95/100): > > Here’s a mobile unit based on a Rockler “Material Mate” [https://www.rockler.com/rockler-material-mate-panel-cart-and-shop-stand](https://www.rockler.com/rockler-material-mate-panel-cart-and-shop-stand) > [@What are your plans for a table?](https://forum.sienci.com/t/what-are-your-plans-for-a-table/95/112): > > Due to a small shop I built my table to tilt, only sticks out about 2’ when tilted. I am planning an external monitor mounted on a tilt/ swivel mount to keep the dust off the laptop. > [@What are your plans for a table?](https://forum.sienci.com/t/what-are-your-plans-for-a-table/95/170): > > [@What are your plans for a table?](https://forum.sienci.com/t/what-are-your-plans-for-a-table/95/238): > > I am currently using this table that I designed and built while waiting for my Longmill to arrive; however, I found that I rarely stowed it vertically and it virtually eliminates the pass-through option for doing projects longer than the machine. Also am looking to upgrade my X axis to 48, so I am designing a new one. However, this design has served me very well to start off with. Personally, I have done a lot of research into tables for the CNC and I have found that everyone has different… --- _[View the full topic](https://forum.sienci.com/t/vertical-storing-options/12052)._