# Y-axis cabling issues

**URL:** <https://forum.sienci.com/t/y-axis-cabling-issues/451>\
**Category:** 🛠️ Assembly\
**Created:** [December 29, 2019, 8:11pm UTC](https://forum.sienci.com/t/y-axis-cabling-issues/451 "2019-12-29T20:11:11Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![sawdustandwoodchips](https://forum.sienci.com/user_avatar/forum.sienci.com/sawdustandwoodchips/32/168_2.png) [@sawdustandwoodchips](https://forum.sienci.com/u/sawdustandwoodchips)\
**Post date:** [December 29, 2019, 8:11pm UTC](https://forum.sienci.com/t/y-axis-cabling-issues/451/1 "2019-12-29T20:11:11Z")

</div>

I have got most of the Long Mill together, and have the Z-axis and router cabling done, but having difficulty following the wiring instructions for the two Y axis - does anyone give me a quick sketch of the routing of the cables?  
many thanks  
Michael

---

<div class="post-metadata">

**Author:** ![GregsReinventions](https://forum.sienci.com/letter_avatar_proxy/v4/letter/g/57b2e6/32.png) [@GregsReinventions](https://forum.sienci.com/u/GregsReinventions)\
**Post date:** [December 29, 2019, 8:42pm UTC](https://forum.sienci.com/t/y-axis-cabling-issues/451/2 "2019-12-29T20:42:03Z")

</div>

They just lay on the table lose and bring to the left side and plug em into the control box.

---

<div class="post-metadata">

**Author:** ![sawdustandwoodchips](https://forum.sienci.com/user_avatar/forum.sienci.com/sawdustandwoodchips/32/168_2.png) [@sawdustandwoodchips](https://forum.sienci.com/u/sawdustandwoodchips)\
**Post date:** [December 29, 2019, 8:44pm UTC](https://forum.sienci.com/t/y-axis-cabling-issues/451/4 "2019-12-29T20:44:04Z")

</div>

Ah! there I was trying to figure out how the all went into the cable track. Think I might run then through holes and under the table.

---

<div class="post-metadata">

**Author:** ![GregsReinventions](https://forum.sienci.com/letter_avatar_proxy/v4/letter/g/57b2e6/32.png) [@GregsReinventions](https://forum.sienci.com/u/GregsReinventions)\
**Post date:** [December 29, 2019, 10:33pm UTC](https://forum.sienci.com/t/y-axis-cabling-issues/451/5 "2019-12-29T22:33:24Z")

</div>

You could. Put something on it where it goes through the table though to provide strain relief ok?