Building a CNC under qualified over engineered

[_Michael]

Welcome to the group!

You might find this thread useful, it’s the only one I can remember on the subject.

SLB Setup on Custom-built, Non-Sienci, ZYYX CNC Machines

I am switching the controller of my custom built ZYYX (based on Nikodem Bartnik’s IndyMill). I was using an Arduino-base GRBL controller. I am currently upgrading cabling and reconfiguring my control console to accommodate a SLB controller. Changing to the SLB and GRBLHAL has a bit of a learning curve, as I am changing from CNCJS to GSender, as well. As I look over the setup for the SLB, I see a couple of issues that I know I will have to address, and probably seek advice from Sienci Labs and t…