Assembly Issue Flange Bearing

While assembling my 30x30 mk 2.5 today I noticed a package of brackets were labelled 48x30. Unfazed I continued on and assembled the xz and y rails with no problms. But when trying to mount the X Gantry to the Y rails the flange bearings are too small for the hole in the Brackets. I think I was sent the wrong brackets…?



1 Like

I’m affraid you are correct. Time to open that ticket and have it resolved.
That’s a nasty bump in your build.

Keep up the smile though. It will be resolved and you will laugh at this in say… 10 years?

20?

Thanx I was afraid i’d done something stupid…But willing to take my lumps…lol. I have sent sienci an email to resolve it…Soooo Now I wait…hahahahahaha… see i’mlaughing already…

1 Like

That didn’t take you long, at all. I took a picture of my 48x30 bracket with the 30x30 bearings on the side just to make it 100% sure, it is not you.

It’s not.

Time for a cupper and a movie.

Thanx for that…but being on the west coast it’ll be another week at least for any thing to be resolved!!

Yaaaaahhh….I finally recieved the 30x30 Y Gantries today…after a couple of minor glitches…(had to re-Tap gantry holes for one stepper motor…all is assembled now, just have to screw it down, tune it and break it in and surface tram etc…Sooooo Happy!!

A week, like you predicted.
Oh well, the tapping aside, let the good times begin!

Enjoy!

Yes…thanx for your support…tuning it was a breeze so far…haha but still hve to secure it and stuff so tomorrow will make some sawdust for sure

1 Like