Entering the LongMill 30x30 in UGS

I want to start using UGS and it’s telling me I need to add a machine. I don’t see Sienci or LongMill on the list. How do I set it up? I know nothing of this, so I need step by step, please

Give the link below a shot if you haven’t yet. It’s a little way down under “Connecting the LongMill to your computer” It’s been a bit since I used UGS but I believe when I set it up I followed the instruction below without a problem. I too was new to this, still am.

You can also try gSender which I think is much nicer/better. Seems like it was basically setup for the longmill as soon as I downloaded/opened it. With the exceptions of a few preference settings. Link below

1 Like