Hi Grant, I zipped and sent the file to your email address thanks for looking at it.
Hi Guys, here is a little trick I read somewhere and the experts have probably seen this but for us newbies it is worth repeating.
When lowering your Z slide a piece of paper on the project. Go into “precise” mode and lower slowly while jiggling the paper. As soon as the paper catches go +Z once, remove paper, then -Z twice and set for zero. This works specially well for sharp fine point that tired old eyes can’t see that well.
I’m going to start closing these old release threads since as soon as a new version is released any comments or issues can be directed to the most recent release feedback thread.
If anyone that reported an issue here is still experiencing it, I would be grateful if you could update me and the development team here : Official 0.7.2 Release Thread: Improvements for endstops, axis setting, and more - #12 by DLare