Inductive sensors

installed my inductive sensors per the video and everything was great. I reset the max travel that went well. I set up a job and hit start job. and it locked up. unlocked machine and retried and it locked up again. I went into the firmware and disabled the switches and I was able to carve my project. I’m stumped and don’t know where to go from here. I actually tried several times to unlock the machine but it continued to lock up and or disconnect while carving. It actually was carving away while the screen showed it was disconnected. So like a idiot I hit connect to machine and shit went further south from there. That’s when I disabled the sensors. I’m sure it something simple I missed in the firmware but I followed the video to a T and everything appeared to be working properly until I loaded a file. Any help is appreciated.

Maybe something in that post will help you.

1 Like