Restarting job slow

gSender 🐛 Bug
4

@Clt49er If you are using UGS GRBL inch switch it over to UGS GRBL mm

I went through this issue back in March, and when I switched the post-processor over to
UGS GRBL mm, the problem was solved. Link to my thread below

Start from Line Moving very slow - gSender / :bug: Bug - Sienci Community Forum

*I think the last time UGS GRBL inch worked fine was on v1.4.10 or before. I can’t remember

*edited my last sentence for clarity

2 Likes