Unable to convert back to XYZ after rotary shut off

Add-ons & Modifications 🌀 Rotary Axis
1

I purchased and installed the Rotary Vortex. Finished my first carve and then was going to go back to surface some boards with normal MK2 machining. I shut off the Rotary Tab in Gsender, switched the A to Y on the box but no matter what I do I cannot get the machine to move more than 4 inches in the y direction.

Any suggestions would be appreciated.

2

@Devildoc87 Welcome to the group, Tony.

When you jog in Y, you say that it only moves 4". Are you saying that you are holding down the Y jog GUI and jogging stops after 4" of movement? If so, what happens when you release the mouse, then hold down again?

Are you using the Long Board, or the Super Long Board?