VCarve Pro Toolpath Question

Software Help Vectric
1

I’m carving a two sided tray. I noticed in the toolpath at the end it’s going to plunge a ballnose bit deep into the walnut wood. I have no idea why the program would allow this move.

image
image652×571 93.7 KB

I tried pasting an image of the toolpath from the visualizer not sure if it worked.

Thanks for any suggestions

2

Just as a note I carved this tray. I paused gsender inserted an IDC HOG endmill which could handle that depth of cut. Minor blemish but otherwise finished carving. Had no issues with bottom side carve.

3

Thought I should include a pic of the project.

image
image1440×1920 215 KB

2 Likes
4

@grahamc001 Post your .crv file if you like.

5

File is to large. Maybe I could email it?

6

@grahamc001 I’ve sent you a private message