WasteBoard Proof of Concept

[mikecmp]

Nice looking boards!

I did a similar project in carbide

Spoilboard project

Alright, editing this post to show the project I actually made. Design: First step was to use some digital calipers to measure my t-nut that I ordered. There are a couple measurements required. Since I want the t-nuts to sit flush in the bottom of the waste board, I need to know the diameter of the base, as well as its thickness. The diameter will be used to mill out pockets for the bases to sit in the base or the board. I also needed to know the diameter of the thread part so I knew what siz…