1.1.0 Hard Stop with errors 33 and 24

I had a hard stop this morning with two error 33 and one 24… (Screenshot and gcode attached)

I was using the same process that works every time from design to post processor, same vacuum and same vac hose all the same but the only difference was the new 1.1.0.

It ran fine for about 45 minutes then when running a last pass for a pocket it decided to just run straight through a solid part that wasn’t to be cut.

Its not a huge deal for me but thought you guys might want to know.
Large H inside cutout.gcode (68.8 KB)