I would like to set proper limits in my machine setup for Fusion360. What are rapid feed rates and max feed rates for x/y/z for an Altmill?
Never mind, it occurred to me that I could look at the firmware settings and I found 15000/15000/6000 for maximum rates for x/y and z.
There seems to be no distinction between rapid feed rate and max feed rates in the firmware.
I also looked to see if I could slow down the speed of the Altmill during some travel moves - specifically if I hit ‘go to zero’ … I am not comfortable with that speed. Alas, I did not find a setting in the firmware for that.