My issue is, after I zero xyz in gsender with my AZTP. I start my cut, it moves around in the lower left corner within a mm and above the surface. I have changed to the AZTP in settings, probe. I have tried different bits and when I switch back to the standard touch plate everything works fine. A…

@SuperDodge RL. As you resolved this on your own, I’ll close this topic. For others with this issue, see here [image] XYZ Probe with AZTP setting wrong Z zero 🐛 Bug I am using v1.2.2 armv7| on a Raspberry Pi 5

Auto zero touch plate

Community Support ❓ Something's Up

gwilki December 21, 2023, 11:52am 3

@SuperDodge RL. As you resolved this on your own, I’ll close this topic. For others with this issue, see here