I use milled lumber so it is not the same thickness for most projects I do. Is there an easy was to change the depth of cut in gsender instead of always changing it in Vcarve then saving it?

I’ll also chime in here just before I close this older thread: Another great way to set Z below the material is to just type it in. For example, if you’ve used a Z-probe or the paper method to set your Z-zero to the top of the material but now want it to cut a little bit deeper, you would: Click …

Changing depth in gsender

gSender ❓ Question

CrookedWoodTex August 26, 2023, 12:13am 9

Well, in case you couldn’t sleep and were just sitting on the edge of your seat waiting for me to post some kind of macro thingy, I have now posted.

Only thing is it isn’t here its over here …