❓ Question

Topic	Replies	Views	Activity
BitSetter and other tool length sensors supported in gSender Can anyone point me to information on using a tool height/offset probe for tool changing? I have a Shapeoko 3 with the BitSetter and I’m going to try setting up gSender instead of Carbide Motion…but glancing through the …	53	9321	March 29, 2026
Gsender freezing after loading a file	3	32	November 1, 2026
Tool length sensor with large diameter tools	4	42	October 31, 2026
Odd behavior with TLS and tool changing	0	23	October 31, 2026
Alarm14 keep triggering	1	26	October 31, 2026
Setting $13 in a macro	0	80	October 28, 2026
Help I am experiencing a persistent homing issue on my AltMil4x4	1	48	October 28, 2026
Probe of BitZero missing Z TLS check?	9	107	October 24, 2026
Trouble with gSender and Huanyang VFD	1	49	October 24, 2026
gSender stops carving	9	160	October 22, 2026
Custom computer commands / notification based on machine state change	3	92	October 21, 2026
Units issue in tool change wizard	3	98	October 18, 2026
Alarms are doing my head in	4	81	October 18, 2026
Alarm 10 triggered during long carves	5	113	October 18, 2026
Mk3 end of job behaviour	6	122	October 7, 2026
Linux - Default Folder for Load File	5	78	October 6, 2026
Problem using BitZero XYZ probe procedure	15	266	October 6, 2026
SLB-lite enthernet connection	13	156	October 5, 2026
Z Axis Calibration Issue	3	71	October 4, 2026
Software becomes unresponsive during 3d carve	2	104	October 1, 2026
Z axis acting up	7	120	September 25, 2026
Files in what order?	2	66	September 19, 2026
Soft Limit Errors - Close to m/c physical limits	1	48	September 19, 2026
Flexible re-zero trouble	4	98	September 15, 2026
Jogging with gamepad	32	1434	September 10, 2026
Changing how homing works	2	116	September 10, 2026
GrblHAL toolchange support	2	119	September 10, 2026
Tool Length Sensor Issues	5	149	September 9, 2026
ATC using the Code segment	6	96	September 8, 2026
Outline bad job and Zero off	1	77	September 1, 2026

BitSetter and other tool length sensors supported in gSender

Can anyone point me to information on using a tool height/offset probe for tool changing? I have a Shapeoko 3 with the BitSetter and I’m going to try setting up gSender instead of Carbide Motion…but glancing through the …