I know that his has been reported before but as the most recent report was closed when @KGN said that this was fixed in 1.4.9, I figured that I would start a new topic.
I am running 1.4.9 on the SLB and a LMv1. CAM is VCarvePro 12. Post is grbl mm
Today’s file was a series of 6 pockets, all the same depth, but different square inch sizes.
At run time of 95%, the job had run for a reported 31 minutes but showed 43 minutes remaining.
At run time of 100% or about 36 minutes, the time remaining was 38 minutes. There was actually only a few minutes left in the file.
The run time kept running after it showed 100%. It stopped at 37 minutes. The time remaining stopped at the same time with 37 minutes still showing.
The actual run time of the job was 40.09 minutes, as reported by gSender at the end of the job.