G Sender change in zero for Z axis

gSender ❓ Question
1

I have been using g sender since it came out and is by far the best g sender I have used.

After it did an up date I went to sent up for a carve and when using the probe it has always gone back to 19 mm, today I did the probe and after the probe it rest back at 7.4 mm and I am afraid to carve on a rather expensive cherry glue up, any help appreciated.
Bill

2

Reset to factory all is well

3

@Bill Thanks for updating, Bill Have fun.

As the original issue has been addressed, I’m closing this topic. If anyone else has a similar concern, feel free to start a new topic, which will ensure that it is addressed promptly.