i built me own CNC as depicted in the Woodsmith magazine. I purchased motors, drives and controller form Buildyoucnc.com. I use Mach3 for the control software. them Machine works very well.
I purchased the GSender Computer, installed it.
When I hooked it up to the CNC machine. It indicates it is connected, but the IDLE block is not there. I’m assuming its not recognizing the controller
On my original computer with the Mach3 software asks for ‘RNR Motion Controller ECO-V20’ And then I’m able to execute the machine.
In the Firmware tab ‘Profile’ tab. I chose ‘Generic CNC’
Flash GBRL’ ask for Port, which I don’t know.
Do we have a solution to my issue?
Joe