Hello all! Received my SLB today and got it setup. This thing moves the axis’ FAST! Directions are correct and everything is smooth except homing. Homing z-axis is flawless and very quick, homing X&Y moves quickly but overshoots the inductive pickups and then shows “disconnected”. Homing seek rate i…

After continuous testing, we’ve found that updating the SLB defaults to: $24 = 150mm/min $25 = 4300mm/min $26 = 25ms $27 = 1.5mm Has resolved homing disconnections and in comparison to the prior settings this will only making the average homing speed about 0.5seconds slower than the prior default…

Issues with Homing

SuperLongBoard 💾Firmware

Norlap April 16, 2024, 8:55pm 12

Just installed my new slb and doing the same thing turns off when i home

SLB Issues: Endstop Buttons, Homing, and X-Axis stalling