Laserbeam not emitting signal to gender version 1.4.9 or light burn! HELP!

[chrismakesstuff]

I’d also refer you to KGN’s response here if you still haven’t got this sorted out:

SLB_LASER not found gSender 1.4.6

First place I’d look is making sure it’s enabled correctly in EEPROM - I’d lean towards it being disabled as an option. We’re going to take a quick tour of the various Spindle settings in the Firmware tool: [image] The first stop is $395, which is the default spindle. In this case, it should by default be setup to the SLB_SPINDLE option. This both enables SLB_SPINDLE as an option as spindle 0 and sets it as default on power up. You’re fine setting this to SLB_LASER if that’s your only spi…