Put M5 nylock nuts into each nut catch on the rear feet

[Paul]

I find the M5 nuts do not really want to insert into the feet… specifically one of the rear was fine, while the other seems pretty hopeless, especially for the nut that’s supposed to drop into the tight corner. Any advice on this assembly step? I didn’t see other posts on this form, but perhaps it is more likely a question for facebook?

[Br5d]

If you line them up the bolt will pull the nut into its seated position.

[nomar]

So, the nuts can be pulled fully into the hex cutouts without damaging the plastic blocks?

[chrismakesstuff]

Yes they can, shouldn’t cause any damage