Replace Acrylic Shield for MK2 Magnetic Dust Shoe

Community Discussion 📄 General
1

My MK2 Magnetic Dust Shoe has taken a beating over the last year, but I’ve found ways to CA Glue and duct tape her back together. I recently shattered the clear plastic piece that resides up and around the endmill. I was wondering if there was a file/resource available for cutting or printing out a repair piece? I could have sworn that I saw somewhere on this forum or the Facebook group that someone posted a link to an STL file to 3D print one, or it was just a template for cutting out a piece of acrylic to the same size.

Either way, appreciate any help.

-Tanner

2

Hi Tanner,

I believe the body is a downloadable stl file found on the open source page.

There is a link to an online cad display where you can at least select the acrylic window.
I have not looked further into it than that, but I bet if you are on the hunt for something, you are able to figure dimensions out there.

1 Like
3

Thank you! Always appreciate the help.