Setting to raise bit after probing

gSender šŸ’” Suggestion
21

Weā€™ll take a look at this - it should be relatively straight forward.

1 Like
22

Thanks All for the feedback. I should have put a few more details in my thread.

I have a 4x4 altmill and use Sienci zero plate, and use g sender.

I am still new to the CNC worldā€¦ only a few months inā€¦ but i have a production project that i run that is roughly 2 mins for one cut and another 2 for the next cut. I swap between a 1/8 in upcut to a 30 v carve bit. and in between i only zero Z axis. So after doing 30-40 of theseā€¦ it would be more effective to have the the spindle move up (after a z zero) so I can put on the dust boot.

It looks like from KGN comment that they will look into it and make adjustmentsā€¦. crossing my fingers.

Thanks again for all the support Matt

1 Like