I have been trying to figure out why Gsender isn’t recognizing my tool changes that I put in Fusion 360. I’ve tried searching for this problem in the forum but I have not found anything.
I don’t know if I am missing something either in Fusion or Gsender? Also almost every time when I send over the gcode from fusion there is a tool change right at the start whether I have tool changes or not.
Any advice or help would be appreciated.
does this page help? Additional Features - gSender Docs you should be able to define how gSender handles M6 commands.
I have read through all of that, but that doesn’t answer why there is a tool change right at the beginning of the program, when I didn’t put one there. Thank you though!
@dehoutwinkel What post processor are you using in Fusion?
I am using GRBL. The only one available that I know about.
@dehoutwinkel Well, that was my shot at it. 
There are fusion 360 experts on th forum, so stay tuned.
Thanks, I appreciate it
