Hi Marty. Thanks for sharing the video from Frank Howarth. It was definitely worth watching. Really interesting design for the vertical table. Much more complex than I am planning. His animations in the video were amazing as well. Very professional! I am moving forward with my design and have gone ahead and purchased most of the pieces I need for the vertical table. I am able to utilize off-the-shelf aluminum stock for everything but the curved end brackets that allow the table to pivot up and down. For those, I traced the brackets from the Legacy Maverick, drew them in VCarve Pro and am having them water jet cut. Great to hear you are making progress on the frame and have your plans finalized. I am also going to put casters on my table. I will use casters that can lift the table to move it when needed, but then will release to let the table sit on the floor. Will be ordering these casters from Rockler. They have the added benefit of being mounted to brackets, so you can remove the casters by pulling out a single pin and move them to other machines / tables in your shop. Rockler Workbench Caster Kit with Quick-Release Plates | Rockler Woodworking and Hardware