Y axis homing wrong direction

Community Support šŸ› ļø Assembly
1

Hello all,

this appears to be an amazing community, and Iā€™m excited to be a part of it.

I just received my AltMill mk2, and after assembly, the X and Z axes home fine, but the Y wants to home at the front of the machine rather than the rear.

Did I wire something improperly, or is there a setting I missed?

Thanks in advance,

Scott

2

@scottwhisler Welcome to the forum. In gSender, under ā€œConfig | Homing/Limitsā€, thereā€™s a ā€œHoming direction invertā€ section. Only the X should be enabled.

Thatā€™s the default for the Altmill, so if it was changed for Y, it might have been changed manually?

3

Thank you. I will check later today.