I think there’s no finer control program than gSender. But why must it always revert to G54? It makes no sense after I’ve set-up and selected G55 for my current project! I snapped a bit today because of it.

That can be very annoying, but it’s not GSender. The G-Code sending the M2 Program End command to GRBL is what resets the workspace. You can Program Events in the GSender settings so it switches back to your selected workspace after the reset. Add the following to Program Start to save the curren…

Don’t feel bad Bill, happened to me too.

I have a special place in my hearth for my early departed lost ones gone to heaven. Hell, I even have a special place in my drawer for them. It’s to remind me of the good times we had, the special projects we made together and how easy it is for me to.. MURDER FRIENDS!!! -walks away sobbing-

GSender Returns to G54!

gSender ❓ Question

gwilki March 21, 2025, 11:12pm 2

@Wills This has come up on the forum before. You can use the search function to see what isreally going on and how to address it. Here are a couple of links to get you started.