From the beginning I have had problems with jobs stopping in the middle, even with surfacing code generated by gsender. Initially I thought it was because of an old computer, and it was better when using the “lightweight” feature. However, I now have a sort of “state of the art” computer hooked u…

In my case, this will probably be the solution! Just finished the 83502 lines of G-Code “Crash Test” on my DIY Arduino GRBL large format plotter. Three hours of work and no USB interruptions and machine freezes. https://amzn.eu/d/55GR7um :+1:

Gsender stops in middle of job or verify

gSender ❓ Question

CharlieMike June 12, 2024, 7:58pm 3

I noticed this thread today that could be what you are describing. (assuming it is an M6 thing)