In the picture you can see I am getting drift. Never had this issue before. File is created in Lightburn and ran with Gsender. I also tried running direct from Light burn and got the same thing. Hoping you can help me sort this if it’s software. I am thinking I have a tired stepper motor at this …

So I flashed the controller and I and back up and running. Now after doing that I realized I missed a learning moment. Checking all the $$ settings everything there matched the settings in the eeprom link, thank you for that. Is there something else I could have downloaded from controller with mor…

Sienci Community Forum

Laser drifting. Bad stepper?

Community Support ❓ Something's Up

← previous page

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled

About this Forum ToS Privacy