I had this start doing this for no reason. I was running a small cabinet build with cutting plywood and putting dadoes in ,it was about a 15 min run time and it just stopped. The error displayed (hit hard stop should home machine again) It was in the middle of the table when this happened. Reset eve…

After all is said and done (noted in my previous posts), I ran all of the toolpaths and Outlines in gSender that previously ‘froze’. I am not sure what the final fix was, but nothing froze after multiple attempts.

Sienci Community Forum

Long Mill Stopping in middle of job

Community Support ❓ Something's Up

← previous page

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled

About this Forum ToS Privacy