Mounting Spoil Board

[_Michael]

Sure, check out my dovetail guide if you like. My table is pretty basic but it works fine. I really like CNCJims setup, it’s further down.

_Michael's Dovetail Guide

The clamping system is pretty simple and holds surprisingly well. Here is the way my spoil boards usually look. [IMG_0059] And for vertical I can remove the first section exposing a slot that I cut using the LongMill. You can see that I have a layer of 3/4" MDF and a layer of 3/4 plywood under that for my table top. The framing is all 2’x4’s. I had to put the router mount in the lower holes to reach when cutting the slot. [IMG_0060] Next is under the table looking at the right side of a h…