today I went to check my alt mill and my controller seams to have a problem. The led inside the controller seams to be dim and flashing. Is it a power problem or a controller problem
@AAGC Have you seen this article: SLB or SLB-EXT - No Power on the Control Board – Sienci Labs
You don’t describe the problems you are having, other than the dim light. What’s not working?
nothing is working anymore. I did check the article and did unplug everything. I don’t have a tester to test the output of the power supply.
@AAGC Your picture shows a circle around the “Halt” light to indicate it’s on. Did you short the e-stop pins as indicated in the document to see what happens?
yes I did and the state is the same
@AAGC I guess it’s time to contact Sienci : Support Form | Sienci Labs
thank for the help I will contact them
ok following about my controller. I read the documentation and it appear that went you connect the usb the led come on and that without the power supply. So my controller is dead because there no led is on on the board. The good news is Steph from Sienci sent me a new controller . I can said that I did have a real good service from Sienci top level.