Water cooling hoses

[Chucky_ott]

@greg5 The hoses will very likely bunch up as the drag chain loops. The further away from the drag chain centreline, the more the hump will be. It may or may not be a problem.

This is what I mean:

From this post:

Any 3d modelers out there

@Headshop Observation #1: we’re probably spending way too much time on this . But I enjoy a good design challenge, so…… Observation #2: your current brackets should work just fine if you compensate for the reduced radius as you’re mounting the tube in the mount. Mark the entire length of tubing where each bracket will be when straight. So essentially equidistant marks at length ‘x’. And when you mount the tube in the brackets around the loop, make sure the marks line up with the bracke…

I think @Headshop eventually went with a bigger drag chain.