My zero buttons are not recognized when I tap them. Is there a command in firmware that I am not finding?

Thanks guys, found that problem thanks to Spamming_Eddie. Turned out that it was simply a matter of $rst=$ followed by turning off the SLB and then turning it back on - magic. Chris

Hi Chris, You are leaving a lot of guesswork on what machine you run, with what controller. I know you have ordered an slb somewhere in 2024. Is this your first time firing up that new device or have you run it succesfully already? What does the status of your machine indicate? Are your zero butto…

Ouch, I’m properly remanded although in my defense I thought this was a straight forward question, my bad. Okay, there is the background information. I’m running a longmill 30x30 on gcode generated out of VCarve PRO generated for Grbl because I cannot get Vcarve generate the gcode using GrblHAL…

Since I don’t have an SLB, and still running an old version of G-sender I cannot be of much use other than maybe redirect you to some info on the matter provided by Sienci. When I look at the page, I feel like G-sender needs to run on hall when using the SLB, but I could be wrong there. [im…

@Spamming_Eddie gSender does need to run grblHal when using the SLB. I believe that @Petamain is referring to the post processor that he should use in VCarve. There is no issue running either grbl inch or grbl mm as the VCarve post processor and running grblHal as the firmware on the SLB-equipped Lo…

Good News! My set zero buttons now work by entering #rst=$ – happy, happy - been working on that since I got the new control unit. Bad news . When I attempt to outline my work the x axis starts grinding as if trying to move past its limit when going left and I get an error 10. I’m guessing tha…

Just to make sure you are connected using grblHAL and not regular grbl? I’m not even sure if you can connect wrong as I don’t have the SLB but thought it was worth a shot. I have gone looking for Alarm and Error codes to try and help with grblHAL issues and the only place that I have found them is …

For what it’s worth, zeroing not working (as in, you hit the button but the WCS didn’t change) on grblHAL is 99.9% of the time due to your $10 EEPROM not being set correctly. If it was set to not include Work Coordinate offsets, gSender has no way to parse current workspace coordinates. [image] …

Sienci Community Forum

Zeroing my router not working

gSender ❓ Question

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled

About this Forum ToS Privacy