Homed my machine, job set up on spoilboard, using the auto zero touchplate, does the Z ok moves slightly to the left and stops giving me a alarm 10. what gives ?

I had updated gsender from 1.5.3 to 1.5.7 and had not cut any file since until today, finally decided to check my probe status and it had changed to the standard touch plate instead of auto zero. Now it works ok . To be honest I had been changing a few settings to learn about the different settings,…

Alarm 10 on XYZ probing

Community Support ❓ Something's Up

Chucky_ott March 12, 2026, 8:11pm 3

@31fordtruck See if this thread applies, although he was getting Alarm 2, not 10