An option to stay on the same workspace after job ends or stops

[gwilki]

@louisbo This has been discussed before. You may want to look at this thread, which explains why gSender behaves as it does and shows a work around that should address your issue.

Workspace reverting to G54 (P1)

I did some work on workspace P1 Moved to P2 so that my P1 0,0 datum was saved. At the end of the first carve on P2, the workspace automatically reverted to P1. It is lucky that I noticed that. I would have expected it to stay on P2 until I manually changed it to another workspace.