X Zero moving to the right when job starts

[Spamming_Eddie]

Hey Kelly,

I am beginning to see a pattern between some problems posted on this very same forum. It begins to smell like a problem with gsender.

Gsender losing X Zero in the middle of a job

I created a 3D tray in Vectric used the tool path array to create a second tray so that I did not have to make as many bit changes. The preview tool path in Vectric did exactly what was intended. I loaded the gcode into Gsender and the job displayed correctly on the visualizer. I started the job and the longmill roughed out the first tray exactly as it should. But, when it started the second tray it did not move to the correct start location so the second rough out. Instead it overlapped wi…

CNC is acting up through project

Hello everyone, I am new on the CNC and i have tried a few times to cut out a design i created on VCarvePro. When i put m g-code into gsender everythiing seems fine but when i start the project, it seems to go wrong part way into it. letters are overlapping, is it a problem with my g-code or something im doing wrong in gsender?

It’s always the x axis that’s the problem. Maybe re-installing the version you had before will solve the issue?

I personaly am running 1.2.2 after encountering trouble in higher-up versions. (I have forgotten what it was, but it was solved after stepping down my gsender version.)